RNP/RNAV approaches — satellite navigation

1 contributors Last edited: Anonym Updated: 14. 6. 2026 Revision history

RNAV / RNP — performance-based navigation and satellite approaches

RNAV (Area Navigation) and RNP (Required Navigation Performance) are the basis of modern air navigation known as PBN — Performance-Based Navigation. Instead of flying along the beams of ground beacons (VOR, NDB), the aircraft flies directly between coordinate points (waypoints) stored in the navigation database. This brought a revolution: direct and shorter routes, continuous descents, higher airspace capacity and above all precise approaches even at airports without ILS — including LPV approaches, which come close to ILS quality but need no ground beacon at all. RNAV/RNP relies mainly on satellite navigation (see GPS/GNSS), supplemented by inertial and ground-based systems.

RNP — accuracy corridor between waypoints WP1 WP2 WP3 ✈ +RNP −RNP RNP X = the aircraft stays within ±X NM of the centreline 95% of the time; exceeding 2×RNP triggers an alert
Instead of beacon beams, the aircraft flies directly between coordinate points. RNP additionally monitors by itself that it does not leave the corridor, and warns in time — that is the main difference from RNAV.

What PBN is — performance-based navigation

The key idea of PBN is that the regulation does not prescribe specific equipment (“you must have a VOR"), but the required performance (“maintain an accuracy of X NM with a given integrity"). How the aircraft achieves it (GNSS, DME/DME, inertial system) is up to the aircraft — what matters is the result. This is called a navigation specification. PBN is defined by ICAO in Doc 9613 and is divided into two families: RNAV and RNP.

History and the transition to PBN

Area navigation is not new — systems allowing flight off beacon beams have existed since the 1970s, but back then they were “sensor-specific" (tied to a specific piece of equipment, e.g. DME/DME or an inertial system). As the ways of determining position multiplied — and above all with the arrival of GNSS — ICAO introduced the PBN concept around 2008 (Doc 9613), which reversed the logic: instead of “what equipment do you have" it asks “what performance can you maintain". This made navigation independent of any particular technology and opened the way to uniform worldwide specifications. Since then there has been a global transition from conventional approaches and routes to PBN: in Europe, EASA is gradually removing redundant conventional approaches, and in the USA the number of LPVs is growing rapidly. For the pilot this means that RNAV/RNP is no longer an “add-on" but an everyday standard.

RNAV vs. RNP — the key difference

Both allow flight between waypoints with a given accuracy. The fundamental difference lies in on-board monitoring:

  • RNAV — the aircraft maintains the required accuracy but does not monitor or report it by itself if it loses it. It relies on the pilot and external systems to oversee performance.
  • RNP = RNAV + on-board performance monitoring and alerting (OBPMA). The aircraft monitors by itself whether it is maintaining the accuracy, and if it is in danger of leaving the corridor, it alerts the crew. That is why RNP is “smarter" and allows tighter corridors where accuracy really matters.

Simply put: every RNP is RNAV, but not every RNAV is RNP. RNP adds self-monitoring.

How performance is “measured"

The number after the abbreviation (e.g. RNP 1) gives the accuracy in nautical miles that the aircraft must maintain for 95% of the flight time — i.e. “I will stay within ±1 NM of the centreline". In addition, PBN defines a containment area: the probability of deviating beyond 2× the RNP value must be extremely small (in the order of 10⁻⁵). With RNP, it is precisely this limit that the on-board system monitors, warning if it is threatened. A smaller number = a narrower and more precise corridor (RNP 0.3 is more precise than RNP 4).

Navigation specifications

PBN has a set of specifications for the different phases of flight:

SpecificationUse
RNAV 5en-route flight in continental airspace (Europe: B-RNAV)
RNAV 1 / RNAV 2en-route, SID and STAR, approach up to the FAF/FAP
RNP 4oceanic and remote airspace (with ADS-C/CPDLC)
RNP 2 / RNP 1en-route (including remote) / terminal airspace, SID/STAR
RNP APCHapproach (LNAV, LNAV/VNAV, LP, LPV minima)
RNP AR APCHdemanding approaches with special authorisation (≤ 0.3 NM on final, turns)
RNP 0.3typically helicopters

There is also the advanced A-RNP (Advanced RNP) with variable accuracy and further functions.

RNP APCH — lines of minima (vertical profile) runway LNAV (lateral only) → MDA, stepdown LPV (SBAS) → DA ~200 ft LNAV/VNAV (baro/SBAS) → DA in between
One RNP approach offers several “lines of minima" depending on equipment: from LNAV (lateral guidance only, higher MDA, stepdown descent) up to LPV (lateral and vertical guidance via SBAS, lowest DA ~200 ft).

RNP approaches and lines of minima

One RNP APCH approach (often labelled “RNAV (GNSS) RWY xx") offers several “lines of minima" depending on how the aircraft is equipped. From the highest (least demanding) to the lowest:

  • LNAV — lateral guidance only (non-precision approach); you descend “in steps" to the minimum descent altitude (MDA).
  • LP (Localizer Performance) — more precise lateral guidance via SBAS, but still without vertical guidance; used where an LPV cannot be published.
  • LNAV/VNAV — lateral guidance + vertical guidance from baro-VNAV (or SBAS); a continuous descent to the decision altitude (DA).
  • LPV (Localizer Performance with Vertical guidance) — lateral and precise vertical guidance via SBAS (EGNOS/WAAS); the lowest minima, DA down to ~200 ft — approaching the quality of an ILS CAT I.

LPV — “ILS without a beacon"

LPV is the pinnacle of RNP approaches, made possible by SBAS (EGNOS in Europe). It gives the pilot guidance similar to an ILS — a glide path and a centreline — but without any ground beacon at the airport. For small and regional airports this is a huge benefit: they get an approach with minima of around 200 ft for a fraction of the cost of an ILS. LPV is therefore spreading quickly (see ILS for comparison).

Vertical guidance: baro-VNAV vs. SBAS

Vertical guidance on an RNP approach can be generated in two ways, and it is good to know the difference. Baro-VNAV derives the glide path from barometric altitude (from pressure), so it is temperature-dependent — at very low temperatures the actual path “sags", which is why temperature limits and corrections are published; below a stated temperature LNAV/VNAV must not be flown without correction. SBAS (with LPV), by contrast, calculates vertical guidance geometrically from the satellite position, so it is independent of temperature and more accurate. This is another reason why LPV is the “royal" line of minima — it gives stable, ILS-like guidance without temperature limitations.

RF legs, turns and RNP AR

RNAV/RNP can also do what beacons could not — curved paths. An RF leg (Radius to Fix) is a precisely defined arc of fixed radius that the aircraft flies as if “on rails". This allows curved approaches around terrain or over populated areas. The most demanding is RNP AR APCH (Authorization Required) — it requires special approval of the aircraft and crew and allows very tight corridors (RNP ≤ 0.3 NM) and curved paths right down to the threshold, typically at airports in the mountains (see challenging airports).

Benefits of PBN

  • Direct and shorter routes — you fly between points, not zigzagging from beacon to beacon → savings in time, fuel and emissions.
  • Continuous descent (CDA/CDO) — quieter and more economical approaches (see Flight levels).
  • Approaches without ground beacons — LPV/LNAV even at small airports.
  • Higher capacity and flexibility of airspace, separated routes, less noise over cities (curved approaches).
  • Lower costs — less ground infrastructure to maintain.

Free Route Airspace — the end of fixed routes

The pinnacle of en-route RNAV is Free Route Airspace (FRA), being introduced in Europe and elsewhere: instead of flying along a fixed airway network, the operator plans a direct route between the entry and exit points of the airspace. This shortens distances further, saves fuel and emissions and increases capacity. FRA is possible precisely because aircraft can navigate precisely by area navigation and do not have to “follow" beacons. It is the logical outcome of PBN: from beacon beams through fixed RNAV routes to free direct flight between points.

Equipment and databases

RNAV/RNP is calculated by the FMS/GPS (see FMS) from a navigation database updated on the AIRAC cycle (every 28 days). Before an RNP approach, the availability of GNSS integrity is checked (RAIM prediction or SBAS). The aircraft must be certified for the specification and the crew trained — especially for RNP AR. An outdated database or unavailable integrity makes the approach impossible.

Czech Republic → Europe → World

In Europe the transition to PBN is managed by EASA; a PBN mandate applies, so conventional approaches are disappearing in favour of RNP and the number of LPVs (thanks to EGNOS) is growing. In the Czech Republic, RNP/LPV approaches are published by ŘLP ČR in the Czech AIP (as of 06/2026); even smaller Czech airports are getting GNSS approaches. Worldwide the framework is ICAO Doc 9613; the USA uses WAAS (LPV is very widespread there), and challenging regions (the Himalayas, the Andes) benefit from RNP AR. The trend is clear: PBN is now the standard, and conventional beacons are retreating to a backup role.

📷 Image placeholder: an RNP/LPV approach in the sim — FMS/GTN 750 and guidance on the PFD
We will add a real photo / screenshot.

In practice — X-Plane / MSFS

  • Programme a flight plan into the FMS/GPS and select an RNAV (GNSS) approach to the destination runway.
  • In equipped aircraft, choose the LPV line of minima and follow the ILS-like guidance on the PFD/HSI — you will see the difference from LNAV (stepdown).
  • In small aircraft the Garmin GTN 750/G1000 is popular — practise activating the approach, “direct-to" and the integrity check.
  • Try a curved (RF) approach in mountainous terrain — you will see the power of RNP.
  • Compare a CDA (continuous descent) with a classic “staircase" descent.

In practice — DCS World

DCS does not model civil PBN/RNP as such. Military navigation, however, runs by waypoints (INS/GPS), which is in principle “area navigation" — you fly directly between points without beacons. Specifically:

  • The F-16C, F/A-18C and A-10C II fly by navigation points (steerpoints) from INS/GPS — the same logic as RNAV (direct to a point).
  • Formal RNP corridors, lines of minima and LPV are not modelled in DCS — use a civil sim to practise RNP approaches.
  • The A-10C II has conventional VOR/ILS (see VOR, ILS); for a “satellite" feel, steerpoint navigation is the closest.

RNAV/RNP vs. ILS/VOR

RNAV/RNP brought flexibility and approaches without beacons; LPV comes close to ILS CAT I. ILS, however, still leads for the lowest minima (CAT II/III) and is independent of GNSS, so it serves as a backup in case of satellite jamming (see GPS — jamming). The VOR is retreating but remains as a backup (VOR MON). Modern operations therefore combine: PBN as primary, ILS/VOR as the safety net.

Safety and limitations

  • GNSS dependence: with jamming/spoofing an RNP approach may become unavailable — have a backup and check the NOTAMs (see NOTAM).
  • Integrity: verify RAIM/SBAS before an RNP APCH; without integrity the approach cannot be flown.
  • Current database (AIRAC): outdated data = wrong routes/minima.
  • The right line of minima: fly only the one your aircraft is equipped for and you are trained for (LPV ≠ LNAV).
  • RNP AR requires special authorisation — no improvising.
  • Confusing similar waypoints: waypoints with similar names are easy to mix up — always check the entered route and approach against the chart and verify the name of the target point.

FAQ

What is the difference between RNAV and RNP? RNP = RNAV + on-board monitoring and alerting; RNP monitors by itself that it is maintaining accuracy, and warns.

What does the number mean (RNP 1)? The accuracy in NM that the aircraft maintains 95% of the time (±1 NM from the centreline); containment is 2× this value.

What is LPV? A precise approach with vertical guidance via SBAS (EGNOS/WAAS), DA down to ~200 ft — an “ILS without a beacon".

How can an approach without a beacon be precise? It is guided by GNSS + SBAS corrections; the aircraft knows its position very accurately and with integrity.

What is RNP AR? An approach requiring special authorisation; very tight corridors and turns, typically in the mountains.

Will RNP completely replace ILS? Not for the lowest minima (CAT II/III); ILS remains and also serves as a backup during a GNSS outage.

Why does LNAV/VNAV have a temperature limit? Vertical guidance from baro-VNAV depends on pressure/temperature; in extreme cold the path is distorted, hence the limits and corrections. LPV (SBAS) does not suffer from this.

What is Free Route Airspace? The option to plan a direct route between the entry and exit points of an airspace instead of flying along fixed airways — thanks to RNAV.

Is there RNP in DCS? Formally no; but military waypoint navigation is in principle area navigation.

Related links


Sources (verified 06/2026): ICAO Doc 9613 (PBN Manual), FAA AIM section 1-2 (PBN/RNAV) and AIP ENR 1.17, EASA (the transition to PBN in the Single European Sky), SKYbrary (RNP / RNP APCH); navigation specifications (RNAV 5/1, RNP 4/1/0.3/APCH/AR APCH), RNP APCH lines of minima (LNAV/LP/LNAV-VNAV/LPV, DA ~200 ft via SBAS), the principle RNP = RNAV + OBPMA and containment 2×RNP verified from multiple sources. For specific procedures/minima in the Czech Republic, see the current Czech AIP (AIRAC).