Contents
Aviation fuel
The type of fuel is determined by the type of engine. Mixing up fuels is a serious mistake — which is why the filler necks and colours are different.
Types
| Fuel | Properties | For |
|---|---|---|
| Avgas 100LL | leaded gasoline, 100 octane, blue | piston engines (gradually being replaced by UL94) |
| Jet A-1 | kerosene; flash point > 38 °C, freezing point −47 °C | jet and turboprop engines |
| Jet B | wide-cut, better in extreme cold, more flammable | extreme cold |
| SAF | sustainable fuel; currently max 50% in a blend | jet engines (CO₂ reduction) |
Consumption (approximate)
Cessna 172 ~36 l/h · Boeing 737-800 ~2,500 l/h · Boeing 777-300ER ~7,500 l/h · Airbus A380 ~12,000 l/h.
Kerosene vs. gasoline
Aircraft use two basic kinds of fuel depending on the type of engine. Jet and turboprop engines burn aviation kerosene — the most widespread is Jet A-1. Piston engines (small aircraft) need aviation gasoline (Avgas), similar to a car's, but in a special grade. Mixing them up is dangerous: putting kerosene into a piston engine (or vice versa) leads to failure. The type of fuel is therefore determined by the type of propulsion (see engines).
Jet A-1 — properties
Jet A-1 is a kerosene fuel with properties tailored to aviation: a flash point of around 38 °C (relatively safe, it does not ignite easily at normal temperatures) and above all a low freezing point (≤ −47 °C), because it is extremely cold at high altitude and the fuel must not freeze. It has a high energy content per kilogram, is relatively stable and contains additives (against icing, static, corrosion). In the USA the similar Jet A is used (a higher freezing point of −40 °C). These properties make kerosene the ideal fuel for long flights at altitude.
Avgas for piston engines
Avgas (Aviation Gasoline) is aviation gasoline for piston engines; the most common is 100LL (“low lead", dyed blue). It still contains lead (for resistance to knocking/detonation in high-performance engines), which is an environmental problem — that is why unleaded substitutes (UL94, G100UL) are being developed and gradually introduced. Avgas is more expensive and less available than kerosene and is filled mainly at small airfields and flying clubs (see Cessna 172).
Sustainable aviation fuels (SAF)
A great hope for reducing emissions is SAF (Sustainable Aviation Fuel) — aviation fuel made from biomass, waste or synthetically, which emits less CO₂ over its life cycle. It is a “drop-in" fuel: it is blended with ordinary kerosene (so far certified up to ~50% blend) and requires no engine modifications. SAF is more expensive today and its production is only just growing, but it is a key tool for making aviation greener (related to CORSIA, see air law).
Fuel density and mass
An important detail: in aviation, fuel is counted in mass (kg/lb), not litres. The reason is that performance and range depend on the energy carried by the mass of the fuel, and volume changes with temperature (warm fuel takes up more litres for the same mass). The density of kerosene is roughly 0.8 kg/l. The crew and the planning (see fuel planning) therefore always work in kilograms/pounds — litres are only for refuelling.
Refuelling and tanks
Fuel is stored mainly in tanks in the wings (and on larger aircraft also in a centre tank in the fuselage, and sometimes in the tail). Large aircraft are filled under pressure through a single point (single-point refuelling) quickly and safely; small aircraft from above through caps on the wings. The order in which fuel is used matters: fuel in the wings “relieves" the wing in flight (wing bending relief), so the centre tank is often used first. The mass and distribution of the fuel affect the centre of gravity (see weight and balance).
Contamination and checks
Fuel must be clean and dry. The main threats: water (from condensation, it settles at the bottom of the tanks — which is why a sample is drained from the sumps before the flight, “sumping", and checked), microbial growth (bacteria/fungi at the water/fuel interface), dirt and the wrong type of fuel. Water in the fuel can freeze in sub-zero temperatures and block the system or cause the engine to fail. Checking the fuel is therefore a fixed part of the pre-flight inspection, especially on small aircraft.
Fuel dumping
Some large aircraft can jettison fuel in flight (fuel jettison/dumping). Why? The maximum landing weight is lower than the takeoff weight — when an aircraft has to make an emergency landing soon after takeoff (e.g. a medical emergency, a failure), it is too heavy with full tanks. By dumping fuel it reduces its weight to a safe level for landing. Not all aircraft can do this (e.g. the 737 cannot, the larger 777/747 can); the others must either circle and “burn off" the fuel or make an overweight landing according to the procedures.
Fuel in the Czech Republic
In the Czech Republic, Jet A-1 is normally available at larger airports (LKPR), while Avgas 100LL is usually found at airfields and flying clubs (its availability is more limited). Fuel quality is subject to standards (internationally ASTM/DEF STAN) and inspections. For a VFR pilot it is good to know in advance where they can get the right fuel — especially Avgas, which is not available everywhere. In Europe and worldwide the same international specifications apply, so Jet A-1 filled in Prague is the same as in London.
Fuel and range
Fuel is the largest variable mass of an aircraft and directly determines its range. More fuel = a longer range, but also a higher weight (and therefore higher consumption and a lower payload). Airlines therefore do not carry “full tanks just in case" but plan exactly the fuel needed with the prescribed reserves (see fuel planning) — unnecessary extra fuel has to be “carried" and costs money. Refuelling is thus always a compromise between range, payload and the economics of the flight.
Practical steps — X-Plane / DCS
In the sim, turn off “unlimited fuel" and plan realistically (see Fuel planning). In DCS, manage the fuel on combat flights: external tanks (drop tanks), Bingo/Joker limits and air-to-air refuelling.
Common mistakes
- Mixing up fuels — Jet fuel in a piston engine (or vice versa) will destroy the engine.
- Water/dirt — take a sample and check it before the flight.
FAQ
Why max 50% SAF? SAF contains few aromatics, which the seals need; that is why it is currently blended with conventional fuel.
What colour is Avgas? 100LL is blue; Jet A-1 is clear to straw-coloured.
Safety and limitations
- Check for contamination — water sinks to the bottom of the tank; take a sample.
- The right type — always verify the fuel for the given engine.
Related links
- Fuel planning · Jet engines
- Glossary — Avgas, JET A-1, SAF, Bingo
Sources (verified 06/2026): multiple sources: fuel specifications (ASTM/DEF STAN), MB Energy, SAF blending limits (aromatics); consumption figures are approximate. An educational summary; for a real flight, use current official documents.