Contents
Boeing 737 — the best-selling airliner
The Boeing 737 is the best-selling airliner in history. Its first flight took place on 9 April 1967, and Lufthansa put it into service in 1968. By 2026 more than 12,500 had been built, with thousands more on order. It is a narrow-body twin-engine aircraft for short and medium routes — the backbone of low-cost and traditional carriers all over the world and also one of the most popular aircraft in flight simulators.
History and development
The 737 was created in the 1960s as a smaller complement to the larger Boeing 727 and 707. To suit small airports without equipment, it was given low landing gear and the ability to use its own airstairs and be loaded without airport equipment — hence its characteristically “low" stance, which it retains to this day. This design proved exceptionally viable: for more than half a century the 737 has been continually modernised rather than being replaced by an entirely new type. The result is a four-generation family that holds the record for the number of airliners built.
Generations
The 737 family is divided into four generations, which differ in engines, avionics and fuselage length:
| Generation | Variants | Engines | From |
|---|---|---|---|
| Original | 737-100 / -200 | Pratt & Whitney JT8D | 1968 |
| Classic | -300 / -400 / -500 | CFM56-3 | 1984 |
| NG (Next Generation) | -600 / -700 / -800 / -900 | CFM56-7B | 1997 |
| MAX | MAX 7 / 8 / 9 / 10 | CFM LEAP-1B | 2017 |
The Originals were noisy, narrow aircraft with cigar-shaped JT8D engines. The Classic brought the more efficient and quieter CFM56 — but its large fan did not fit under the low wing, so it got a characteristic flattened nacelle (the engine is “cut off" at the bottom). The NG is still the most widespread generation (more than 7,100 built); the 737-800 model is the “workhorse" of low-cost carriers such as Ryanair. The MAX is the newest generation, with LEAP-1B engines and even lower fuel burn.
The 737-800 — the workhorse of the skies
If you picture a typical 737, it is most likely a 737-800 from the NG generation: roughly 160–189 seats, a range of around 2,900 NM, ideal for European and domestic routes. It is this model that flies with most low-cost carriers and is the most frequently modelled 737 in simulators.
Construction and controls
Unlike the Airbus A320, the 737 does not have full fly-by-wire — the controls are largely conventional (mechanical and hydraulic), the pilot flies the aircraft with a classic control wheel (yoke) and has a more direct “feel" of the control surfaces. The hydraulics consist of two systems (A and B) plus a backup Standby system (see Hydraulic system). Boeing's philosophy emphasises that the pilot has the final say (for a comparison see Airbus vs. Boeing).
The MAX and the MCAS affair
The MAX generation was marked by two tragic accidents (Lion Air 2018 and Ethiopian Airlines 2019) linked to the MCAS system (Maneuvering Characteristics Augmentation System). MCAS was meant to compensate for the different behaviour caused by the larger and differently positioned LEAP engine, but it relied on a single angle-of-attack sensor and, when that sensor failed, repeatedly pushed the nose down. After these accidents the type was grounded worldwide; there followed a redesign of MCAS (two sensors, limited authority), new crew training and a reform of the certification process. The MAX then returned to service. It is a textbook case of how automation, design and certification must go hand in hand with human factors (see Air accidents).
Systems and cockpit
The 737 NG has a glass cockpit with a PFD/ND and an FMC (see FMS); the autopilot is controlled via the MCP (Mode Control Panel). The MAX added larger displays. Despite the modernisations, the 737 has retained many elements from earlier generations (which is why a common type rating within the family is relatively easy), saving airlines training costs.
In simulators
- X-Plane: the Zibo Mod 737-800 — free and a top-notch study-level Boeing, one of the best freeware add-ons ever.
- MSFS: the PMDG 737 (the gold standard), iniBuilds.
- P3D: the PMDG 737 NGXu.
- The IXEG 737 Classic (X-Plane) for fans of the older generation.
Thanks to its conventional controls and extensive documentation, the 737 is a great aircraft on which sim pilots learn airliner operations, from a cold & dark start to landing.
Operations and operators
The 737 is the domain of short and medium routes. It is operated by hundreds of airlines — from the low-cost giants (Ryanair, Southwest, which bet on a single-type 737 fleet) to traditional carriers. A single-type fleet greatly reduces the costs of training, maintenance and spare parts, which is one of the reasons for its commercial success.
Curiosities
- The low landing gear is a legacy of the 1960s (loading without equipment) — hence the “flattened" engine nacelles on the NG.
- Older 737s had so-called eyebrow windows above the windscreen, later blanked off.
- A common type rating across generations makes it easier for crews to transition.
Competition and the future
The 737's long-standing rival is the Airbus A320 (and its neo) — the battle between these two narrow-body families has lasted for decades, and both have passed ten thousand deliveries. While Airbus bet on fly-by-wire and a common type rating across the family, Boeing has been modernising the proven 737 over the long term. There is speculation about an entirely new narrow-body type to replace the 737, but for now the MAX remains the flagship. For pilots and passengers this means that the 737 and A320 will remain the most common airliners in the sky for a long time to come — and therefore in simulators too, where they are “standard equipment" for anyone who wants to fly airliners.
FAQ
Which version is best for learning in the sim? The Zibo 737-800 (X-Plane, free) or the PMDG (MSFS) — both are very faithful.
Does the 737 have fly-by-wire? Not like the Airbus — the controls are largely conventional; the pilot has a more direct link to the surfaces.
What was the MCAS affair? A fault in a system dependent on a single sensor in the MAX generation; it led to the grounding and a redesign.
Why is it so widespread? Fifty years of modernisation, single-type fleets at airlines, low operating and training costs.
What is the difference between the NG and the MAX? The MAX has more efficient LEAP-1B engines, larger displays and aerodynamic changes; the NG is older but the most widespread.
Specifications (737-800, NG generation)
| Parameter | Value |
|---|---|
| Length | ~39.5 m |
| Wingspan | ~35.8 m (with winglets) |
| Capacity | ~162–189 passengers |
| Range | ~2,900 NM |
| Cruise speed | ~M 0.78–0.79 |
| Engines | 2× CFM56-7B |
The 737-800 is the “middle" member of the NG family and the reference type most people picture as “a 737". The smaller 737-700 and the larger 737-900 share the systems and cockpit and differ mainly in fuselage length and capacity. The MAX generation has similar dimensions with more efficient engines and other changes.
Engines across the generations
The development of the 737 is largely the story of its engines. The Original flew with narrow Pratt & Whitney JT8D engines (noisy, cigar-shaped). The Classic got the modern CFM56-3 — but its large fan did not fit under the low wing, so it has the characteristic flattened nacelle (the engine “cut off" at the bottom). The NG uses the more powerful CFM56-7B, and the MAX the most modern CFM LEAP-1B with a large fan (hence the MAX's nacelle being moved forward and mounted higher, which is also related to MCAS). Each generation thus reduced fuel burn and noise.
High-lift devices and aerodynamics
The 737 is known for its sophisticated high-lift devices: on the trailing edge it has triple-slotted flaps and on the leading edge slats and Krueger flaps. Thanks to this it can land and take off from relatively short runways and at smaller airports — which was one of the design goals from the start. Later generations added winglets (and the MAX the curved “AT winglets") for lower drag and fuel burn. This combination makes the 737 an all-rounder for short and medium-length routes.
Systems: hydraulics, electrics, pneumatics
The 737 has largely conventional systems (unlike the fly-by-wire Airbus):
- Hydraulics — two main systems, A and B, plus a backup Standby system, which power the flight controls, landing gear, flaps and brakes (see Hydraulics).
- Electrics — generators on both engines, the APU and a standby battery (see Electrics).
- Pneumatics / bleed air — air bled from the engines for pressurisation (see Pressurisation), air conditioning and anti-icing.
The conventional approach means the pilot has a more direct link to the control surfaces and a “feel" for the aircraft; at the same time they must understand the systems better, because the automation does not shield them from them as much.
Takeoff, landing and performance
737 operations are governed by performance speeds: V1 (decision speed — after it the takeoff is no longer rejected), VR (rotation) and V2 (takeoff safety speed). Takeoff flaps are usually set at 1–5, landing flaps at 30–40. On landing, spoilers (lift dumpers), thrust reversers and autobrakes are used. The target speed over the threshold depends on weight and flaps. These procedures are faithfully modelled in the sim (Zibo/PMDG) and are great practice for airline operations from a cold & dark start to landing.
Variants: passenger, cargo and BBJ
Besides the passenger versions there are also cargo 737s (BCF/BDSF — passenger-to-freighter conversions, popular with parcel carriers) and the luxurious BBJ (Boeing Business Jet) — a VIP/corporate version of the 737 with a long range and a private interior. Historically, 737s also served in a mixed (combi) configuration and in military roles. This flexibility is another reason for its commercial success — one basic type covers a range of needs.
The Boeing 737 in Czechia and Europe
In the Czech Republic the 737 is well known: the largest Czech carrier, Smartwings (formerly Travel Service), operates a fleet of Boeing 737s (NG and MAX) from Prague and seasonally from other airports. In Europe the 737 is the backbone of the low-cost giants — Ryanair is the largest 737 operator in Europe (worldwide it is Southwest) and bet on a single-type fleet (the 737-800 and the MAX 8 “Gamechanger"). A single-type fleet fundamentally reduces the costs of training, maintenance and spare parts — which is why the 737 is ideal for European low-cost carriers (see LKPR).
Accidents and safety lessons
The 737's long service has also brought lessons that have advanced safety:
- Rudder problems (737 Classic) — the United 585 (1991) and USAir 427 (1994) accidents were caused by a fault in the rudder servo (rudder hardover); this led to a redesign of the rudder control system.
- Helios 522 (2005, 737-300) — an incorrectly set pressurisation system and a mishandled warning led to crew hypoxia; a fundamental lesson about the pressurised cabin and warnings (see Pressurisation).
- The MAX and MCAS (2018–2019) — see above; it led to a worldwide grounding, a redesign of the system and a reform of certification.
Each of these events led to specific changes in design, training or regulations — an illustration of how aviation retroactively increases safety (see Air accidents).
Why the 737 has survived for over 60 years
Instead of being replaced by an entirely new type, the Boeing 737 has been continually modernised for more than half a century. The reason is economic: a common type rating across generations and a huge operational base (pilots, technicians, spare parts, documentation) make the 737 exceptionally cheap to introduce and operate. Airlines can thus expand their fleets without costly retraining. This “evolution instead of revolution" is the secret of its record commercial success — and also the source of some compromises (e.g. the low landing gear inherited from the 1960s).
The cockpit and crew work
The 737 is flown by a two-pilot crew (captain and first officer). The cockpit has a classic control wheel (yoke), moving thrust levers (unlike the Airbus they physically move — the pilot sees and feels what the autothrottle is doing), the MCP (Mode Control Panel) for the autopilot and the FMC/CDU for the flight plan (see FMS). Overhead is the overhead panel with the systems (electrics, hydraulics, fuel, air conditioning), which are operated during a “cold & dark" start and checked according to checklists. The work is divided between the pilot flying (PF) and the pilot monitoring (PM), with an emphasis on communication and cross-checking (see CRM). The glass cockpit (NG/MAX) displays everything on the PFD/ND (see Glass cockpit).
Maintenance and life cycle
Like every airliner, the 737 undergoes graduated maintenance: from daily line checks through A-checks (every few hundred flight hours) to extensive C- and D-checks (after years, when the aircraft is taken apart and inspected in depth). On short routes, the number of cycles (takeoff–landing with cabin pressurisation) is key, because repeated pressurisation stresses the fuselage — which is why its service life is counted mainly in cycles, not just hours. At the end of their passenger careers, many 737s are converted to freighters (BCF) and continue in service. Thanks to the huge fleet and demand, the 737 holds its value well on the used aircraft market.
Related links
- Airbus A320 · Airbus vs. Boeing · FMS · Autopilot
- Hydraulics · Air accidents · Aircraft database · Glossary — MCP, FMC, MTOW, turbofan
Sources (verified 06/2026): the manufacturer Boeing and public delivery statistics (over 12,500 by 2026, NG over 7,100), Wikipedia (Boeing 737 / 737 MAX), MCAS reports (NTSB/KNKT/EthCAA); the generations, engines and first flight on 9 April 1967 verified from multiple sources.