Lesson 16: Boeing 737 — cold and dark start

Simulator: Lekce 16: Boeing 737 — studený start

Boeing 737 — cold & dark startup

The complete start-up procedure of the B737-800 from an empty cockpit.

Initial power-up

  1. Battery ON
  2. Standby power AUTO
  3. Wait for the ISFD self-test

Electrical power

  1. Generator switches OFF
  2. APU switch → START
  3. Wait for the APU to run (EGT rise, RPM stabilises)
  4. APU GEN switches ON

IRS alignment

  1. IRS selectors → NAV (both)
  2. Wait about 7–10 minutes for the alignment

Hydraulics

  1. Confirm the engine HYD pumps ON
  2. Electric HYD pumps ON

FMC programming

  1. INIT REF page → enter the position, cost index
  2. RTE page → origin/destination, route
  3. PERF INIT → ZFW, fuel, reserves
  4. N1 LIMIT → select the derate

Engine start

  1. Engine start switch → GRD (usually engine 2 first, per the operator's SOP)
  2. Monitor the N2 rise and oil pressure
  3. At ~25% N2 (or maximum motoring) → engine start lever → IDLE
  4. Monitor the fuel flow, then the EGT rise
  5. At ~56% N2 the starter cuts out (the switch returns to OFF) — the engine stabilises at idle
  6. Repeat for the other engine